As of January 15th, 2026, we now provide very rudimentary support for GoPro cameras. It works on both Windows and Raspberry Pi (best way to extend beyond 24 units)

Instructions:

• connect your GoPro cameras by USB to your Windows based computer

• Accept the terms and use default settings

• On the QR code page (when GoPro asks you to connect to your phone), click “back” to bypass this step

• launch Xangle, reorder the cameras, set them to “single” or “video” from the trigger modes in Xangle, and trigger! (there’s no configuration required on the cameras)

• Raspberry Pi: Please flash with the latest image (i12+) and update all pis (/nodes modules). You should be at client version 12.3.0 at minimum

  

Supported:

• Photo (single), Video, Night
• Settings change
• Trigger
• Sync time (below the trigger modes on the dashboard)
• Usual Xangle functionalities (playback, countdown, sharing, lights, trigger actions, etc etc)

Limitations:

• Tested with HERO13 only
• Settings are quite flimsy. You need to click on the trigger mode (single or video) after you launch the app
• RAW mode is not supported at the moment