As of January 15th, 2026, we now provide very rudimentary support for GoPro cameras. It works on both Windows and Raspberry Pi (best way to extend beyond 24 units)

Instructions:

• connect your GoPro cameras by USB to your Windows based computer
• launch Xangle, reorder the cameras, set them to “photo” mode, and trigger! (there’s no configuration required on the cameras)

Limitations:

• Tested with HERO13 only
• Settings are quite

To run the GoPro without an internal battery and prevent overheating during long sessions, you must use the GoPro Labs firmware to bypass the camera's hardware power check. Once the Labs firmware is installed, scan the QR code below containing the !MTUSB=1 command; this "Trust USB" flag forces the camera to ignore power-handshake requirements and operate solely on external USB power (minimum 5V/2.4A recommended). This "bypass mode" significantly reduces heat generation by eliminating the battery charging circuit, ensuring stable performance for continuous recording or SDK-controlled environments.

https://www.instagram.com/p/DTbGumCj7Eo/